The device is used for preventive and treatment of various diseases caused by helminths, protozoa, bacteria, viruses, mites and other parasites.The curative effects on human beings by using variable-frequency electrical pulses that violate the metabolism of parasites.
Structure and Composition of the device ZP1000: Set the device consists of an electronic unit and two copper cylindrical electrodes. The device is supplied with light and sound indication.
The front panel of the device contains the following:
1 - red LED READY;
2 - Stop button procedure STOP;
3 - Rotary switch to select a range of scanning frequencies;
4 - switch button procedure START;
5 - connectors for connecting the working electrode;
6 - green LED POWER;
7 - LED Zapper.
On the side of the device contains the following:
8 - Rotary switch selection pulse amplitude;
9 - the operating switch (universal frequency of 432 kHz / scanning frequency);
At the back of the device is a network switch, network safety and output power cord.
SPECIFICATIONS
Power supply .................................... ~ 220 V, 50 Hz;
Maximum output amplitude ............. 10, 15, 30 volts;
Automatic timer - 8 minutes 30 seconds;
Audible sound indication for start and end a session effect.
Scanning frequency ranges:
Against the slime molds ........................................ 77 - 150 kHz;
Against molds ................................................ ......130 - 295 kHz;
Against viruses and bacteria ................................ 270 - 430 kHz;
Against the protozoa and roundworms ............... 350 - 470 kHz;
Against the warst and tape worms ........................400 - 490 kHz;
Against mites ........................................................ 670 - 880 kHz.
Universal Frequency ...................................................... 432 kHz.
Working Procedure
Stick the plug into the socket ~ 220 volts.
Enable network toggle on the back of the device.
This LED lights READY and heard a brief sound signal.
The turning switch 8 to select voltage amplitude of electrical pulses.
Switch 9 on the side of the device to select mode.
If you select a fixed frequency of 432 kHz, the LED 7 ZAPPER on top of the instrument is off. If you select ZAPPING (scan mode frequency), the LED glows 7 ZAPPER. Then, turning switch 3 selects the range of scanning frequencies.
Connect the plug of the cable working electrodes to the terminals 5 in the front of the device. The red wire connects to the red connector. Working electrodes were recommended to wrap toilet paper and moisten it with water. The electrodes are taken in hand (the electrode with the red wire - in the right hand).
When you click on the START button alarm sounds and lights up green LED POWER. This automatically activates the scanning generator, the electrodes are fed the appropriate electrical pulses and starts the process bioresonance therapy. Hands should keep on their knees.
The procedure is measured built-in timer. After the procedure, the signal sounds, POWER LED goes out, lights up and READY LED device automatically goes into Standby mode.
The procedure is repeated three times with intervals of 5-10 minutes.
Prior to the session and during breaks is recommended to use 150 ml of water.
When switched on the device electrodes touch each other, it will sound the signal for the presence of voltage pulses.
After the therapy, switch off the appliance network tumbler.
During the day 2-3 sessions of therapy.
The course of therapy 7-10 days.
Contraindications
Pregnancy
Children under 5 years
The presence of pacemaker
Epilepsy